Planting Instructions for APS 6

The Accelerated Propagation System (APS) is a complete self-watering growing system that makes starting your own plants easier than ever before. The APS-6 will keep your seedlings well tended until you're ready to plant them outside. Each cell in the planting tray is designed to hold one transplant.

medium garden cart

Planting Instructions for APS 6
1. Moisten approximately 6 quarts of finely milled soilless germinating mix with 4 cups of lukewarm water until the mix feels slightly damp. We recommend our Germinating Mix.

2. Place the Planting Tray (A) on a flat surface, then fill each cell half-full with the moistened soil. Firmly press the soil into each planting cell so that it will have good contact with the Capillary Mat below. Place the transplants in the cells and fill in around them with the mix, gently pressing the mix around the roots.

3. Moisten the Capillary Mat (B) then lay it on the Pegboard Stand (C) with the mat extending over the unnotched end.

4. Place the Pegboard Stand (C) and mat in the reservoir (D), peg side down. Make sure the extended end of the mat is inside the reservoir. Fill the reservoir with water at the notched end of the Pegboard Stand. You can check the level of the water by looking into the notched opening.

5. Place the Planting Tray (A) on top of the capillary mat and stand, then lift it up again to make sure the soil has touched the mat under each cell. To ensure capillary action is established, the soil in the bottom of each cell must make contact with the mat. If the soil has not made contact, set the planting tray on a hard surface, firm the soil, then place the tray back on the Capillary Mat.

6. After planting, water the soil thoroughly from above. Watering the soil from above ensures that the soil will have good moisture contact with the matting and continue to wick moisture from the matting to the soil inside each cell.

Tips on Growing with the APS

Providing Light:
Be sure to provide adequate light for young plants. Indoor artificial lighting provides a constant, controllable source of light that is better than winter sunshine. Leave the lights on for 14 to 16 hours a day and keep the bulbs one to two inches from the seedlings by raising the lights as the plants grow.

If you do not use grow lights, place the APS in a large south or southwest window. Rotate the APS daily to help keep the plants from leaning toward the light.

Temperature:
After germination, most young plants grow better in cooler air temperatures (65 to 70 degrees F). This will help reduce legginess. Good air circulation is also important.

Watering:
The APS Water Reservoir will hold enough water to keep the Capillary Mat moist for about 5 days. Check the water level regularly. Add water through the notched end of the Pegboard Stand.

The mat should be damp at all times. If it dries out, thoroughly moisten the mat to reestablish the capillary action before replacing it under the growing cells. If the soil seems too wet, remove the mat for a couple of days so the soil can dry out.

To keep roots from growing into the capillary mat, lift the Planting Tray off the mat once or twice a week.

Fertilizer:
To ensure a constant supply of nutrients for your seedlings or transplants, a diluted solution of liquid fertilizer may be added to the water reservoir. Foliar fertilizers can be sprayed onto plant leaves to keep plants stocky and healthy.

Transplanting:
Your seedlings should be hardened off slowly before they’re planted in the garden. Do this by placing them outside for a few hours each day for 1 to 2 weeks, gradually increasing exposure to sunlight and wind.

Once you have transplanted your seedlings into the garden, you may want to plant a second crop of seeds and place the APS directly outdoors. The seeds will germinate quickly in the springtime sun and can then be transplanted into the garden.

Reusing the APS:
Wash your APS thoroughly with warm water to remove soil and other debris from surfaces. Soak the Capillary Mat in a diluted bleach solution and rinse in clean water. Store the entire unit away from sunlight when not in use.

Our APS units are ozone-friendly because they are made of CFC-free polystyrene. With careful handling they will last for several years.

If you have any questions, contact us at: info@gardeners.com

Share This Article